User`s manual
2
Hardware Installation
41
2.10.15 Wake-On-LAN Connector
The system board supports the Wake-On-LAN function. This function
will allow the network to remotely power-on a Soft Power Down
(Soft-Off) PC. However, if your system is in the Suspend mode, you
can power-on the system only through an IRQ or DMA interrupt.
To use the Wake-On-LAN function, you must enable the Resume on
LAN field in the Power Management Setup of the BIOS. Your LAN
card package should include a cable. Connect one end of the cable
to the wakeup header on the card and the other end to location
J16 on the system board. The network will detect Magic Packet and
assert a wakeup signal to power-up the system. Refer to the add-in
cards manual for details. Note: Your LAN card must support the
remote wake up function.
Important:
The 5VSB power source of your power supply must support
≥
720mA.
Pin
1
2
3
Function
WOL
Ground
+5VSB