User`s manual

64
3
Award BIOS Setup Utility
Resume On LAN
If you are using a LAN card that supports the remote wake up
function, set this field to Enabled. The will allow the network to
remotely wake up a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can wake up the system
only through an IRQ or DMA interrupt. Refer to Wake-On-LAN
Connector in chapter 2 for more information.
Resume On Alarm
Enabled When Enabled, you can set the date and time you
would like the Soft Power Down (Soft-Off) PC to
power-on in the Date (of Month) Alarm and Time
(hh:mm:ss) Alarm fields. However, if the system is being
accessed by incoming calls or the network (Resume On
Ring/LAN) prior to the date and time set in these
fields, the system will give priority to the incoming calls
or network.
Disabled Disables the automatic power-on function. (default)
Date (of Month) Alarm
0 The system will power-on everyday according to the
time set in the Time (hh:mm:ss) Alarm field.
1-31 Select a date you would like the system to power-on.
The system will power-on on the set date, and time set
in the Time (hh:mm:ss) Alarm field.
Time (hh:mm:ss) Alarm
This is used to set the time you would like the system to power-on.
If you want the system to power-on everyday as set in the Date
(of Month) Alarm field, the time set in this field must be later than
the time of the RTC set in the Standard CMOS Features submenu.