User`s manual

58
3
Award BIOS Setup Utility
system and remove the battery. Wait for a
few seconds and install it back before
powering-on the system.
Hot Key When this option is selected, move the cursor to
the KB Power On Hot Key field to select a
function key you would like to use to power-on the
system. The options are from Ctrl-F1 to Ctrl-F12.
Mouse Left When this option is selected, double-click the left
button of the mouse to power-on the system.
Mouse Right When this option is selected, double-click the right
button of the mouse to power-on the system.
Any Key Press any key to power-on the system.
Keyboard 98 When this option is selected, press the wake up
key of the Windows

98 compatible keyboard to
power-on the system.
Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto The system will automatically select an I/O address for
the onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3 Allows you to
manually select an I/O address for the onboard serial
port 1 and serial port 2.
Disabled Disables the onboard serial port 1 and/or serial port 2.
UART2 Mode Select
The system board supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J12) and the COM 2 serial port (J11) at the same time. If
you are using the COM 2 serial port, make sure this field is set to
Normal.
To use the IrDA function, follow the steps below.
1. Connect your IrDA cable to connector J12 on the system
board.