User`s manual

2
Hardware Installation
31
The system board supports the Wake-On-USB Keyboard function.
This function allows you to use a USB keyboard to wake up a
system that is in the S3 (STR - Suspend To RAM) state. If you want
to use this function, you must set jumper JP1 or JP4 pins 2 and 3 to
On and set USB KB Wake Up From S3 in the Power Management
Setup submenu of the BIOS to Enabled. Refer to Jumper Settings
for Wake-On-USB Keyboard in chapter 2 and USB KB Wake-Up
From S3 in the Power Management Setup section in chapter 3 for
more information.
J14
for USB 3 and USB 4
Pin
1
3
5
7
9
Function
VCC
-Data
+Data
Ground
Key
Function
VCC
-Data
+Data
Ground
Ground
Pin
2
4
6
8
10