User`s manual

33
2
Hardware Installation
Front Audio
The front audio connector (JP7) allows you to connect to the line-
out and mic-in jacks that are at the front panel of your system.
Using the line-out and mic-in jacks will disable the rear audio’s line-
out and mic-in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of JP7 prior
to connecting the front audio cable connector. Make sure pin 1 of
the cable connector is aligned with pin 1 of JP7. If you are not using
this connector, make sure to replace the jumper caps back to their
original pin locations.
Driver Installation
Install the audio drivers. Refer to chapter 4 for more information.
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open