User`s manual

www.dfi .comChapter 3 Hardware Installation
26
Chapter 3
Signal Pin# Pin Type Pwr Rail /Tolerance PU/PD Description
SPI_CS# B97 O CMOS 3.3V Suspend/3.3V Chip select for Carrier Board SPI - may be sourced from chipset SPI0 or SPI1
SPI_MISO A92 I CMOS 3.3V Suspend/3.3V Data in to Module from Carrier SPI
SPI_MOSI A95 O CMOS 3.3V Suspend/3.3V Data out from Module to Carrier SPI
SPI_CLK A94 O CMOS 3.3V Suspend/3.3V Clock from Module to Carrier SPI
SPI_POWER A91 O 3.3V Suspend/3.3V Power supply for Carrier Board SPI – sourced from Module – nominally
BIOS_DIS0# A34
BIOS_DIS1# B88
Si
g
nal Pin# Pin T
yp
e Pwr Rail
/
Tolerance PU
/
PD Descri
p
tion
V
GA
_
RED B89 O Analo
g
A
nalo
g
PD 150
R
Red for monitor. Analo
g
out
p
ut
VGA_GRN B91 O Analog Analog PD 150R Green for monitor. Analog output
VGA_BLU B92 O Analog Analog PD 150R Blue for monitor. Analog output
V
GA
_
HSYNC B93 O CMOS 3.3V
/
3.3
V
Horizontal s
y
nc out
p
ut to VGA monitor
V
GA
_
VSYNC B94 O CMOS 3.3V
/
3.3
V
V
ertical s
y
nc out
p
ut to VGA monitor
V
GA
_
I2C
_
C
K
B95 I
/
O OD CMOS 3.3V
/
3.3
V
PU 2.2K to 3.3
V
DDC clock line
(
I2C
p
ort dedicated to identif
y
VGA monitor ca
p
abilities
)
V
GA
_
I2C
_
DAT B96 I
/
O OD CMOS 3.3V
/
3.3
V
PU 2.2K to 3.3
V
DDC data line.
Si
g
nal Pin# Pin T
yp
e Pwr Rail
/
Tolerance PU
/
PD Descri
p
tion
I2C_CK B33 I/O OD CMOS 3.3V Suspend/3.3V PU 2.2K to 3.3VSB General purpose I2C port clock output
I2C_DAT B34 I/O OD CMOS 3.3V Suspend/3.3V PU 2.2K to 3.3VSB General purpose I2C port data I/O line
SPKR B32 O CMOS 3.3V / 3.3V Output for audio enunciator - the "speaker" in PC-AT systems.
This port provides the PC beep signal and is mostly intended for
debugging purposes.
WDT B27 O CMOS 3.3V / 3.3V Output indicating that a watchdog time-out event has occurred.
KBD_RST# A86 I CMOS 3.3V / 3.3V PU 10KW to 3.3V Input to Module from (optional) external keyboard controller that can force a reset. Pulled high on
the Module. This is a legacy artifact of the PC-AT.
KBD_A20GATE A87 I CMOS 3.3V / 3.3V PU 10KW to 3.3V Input to Module from (optional) external keyboard controller that can be used to control the CPU
A20 gate line. The A20GATE restricts the memory access to the bottom megabyte and is a legacy
artifact of the PC-AT.Pulled high on the Module.
VGA Si
g
nals Descri
p
tions
Miscellaneous Signal Descriptions
SPI Signals Descriptions
I CMOS NA Selection straps to determine the BIOS boot device.
The Carrier should only float these or pull them low, please refer to
COM Express Module Base Specification Revision 2.1 for strapping options of BIOS disable signals.