User`s manual
Table Of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - Watchdog Sample Code
- Appendix B - System Error Message
- Appendix C - Troubleshooting
- Appendix D - NLITE and AHCI Installation Guide

Introduction
1
8
Processor
Chipset
System Memory
Expansion Slots
Graphics
Audio
LAN
Serial ATA
Chapter 1 - Introduction
Specifications
• LGA 775 socket for:
- Intel
®
Core
TM
2 Quad / Intel
®
Core
TM
2 Duo
- Intel
®
Wolfdale 45nm processors
• Supports Intel Enhanced Memory 64 Technology (EMT64T)
• Supports Enhanced Intel SpeedStep Technology (EIST)
• 1333*/1066/800MHz FSB
*Available on CPUs that support 1333MHz FSB
Note: We recommend using screw with metal pad type of CPU
heat sink and fan.
• Intel
®
chipset
- Intel
®
Q35 Express chipset
- Intel
®
ICH9 I/O Controller Hub
• One 240-pin DDR2 DIMM socket
• Supports 667MHz and 800MHz DDR2 SDRAM
• Supports maximum of 4GB system memory using 512Mbit or
1Gbit technology for x8 and x16 devices
*ECC DDR2 DIMMs are not supported
• 1 PCI slot
• Integrated Intel GMA3100
- Up to 384MB maximum video memory
- 2048x1536 at 75 Hz maximum resolution
• LVDS interface (BL100-N and BL100-P only)
- Panel support up to UXGA (1600x1200)
- LVDS 18-bit or 24-bit output through SDVO interface
- Single/dual LVDS transmitter up to 165M pixels/s
Note: The default BIOS does not support LVDS. Please request
for a customized BIOS to support LCD panel using the
LVDS interface.
• Realtek ALC662 High Definition audio CODEC
• Six channel DAC supports 16/20/24-bit PCM format for 5.1
channel audio solution
• All DAC support independent 44.1k/48k/96kHz sample rate
• All ADC support independent 44.1k/48k/96kHz sample rate
• One Realtek RTL8111C PCI Express Gigabit controller
(BL100-P and BL100-PE only)
• Two Realtek RTL8111C PCI Express Gigabit controllers
(BL100-N and BL100-NE only)
• Supports 10Mbps, 100Mbps and 1Gbps data transmission
• IEEE 802.3 (10/100Mbps) and IEEE 802.3ab (1Gbps) compliant
• Supports 4 SATA (Serial ATA) interfaces which are
compliant with SATA 1.0 specification
• SATA speed up to 3Gb/s