User`s manual
Table Of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - Watchdog Sample Code
- Appendix B - System Error Message
- Appendix C - Troubleshooting
- Appendix D - NLITE and AHCI Installation Guide
45
2
Hardware Installation
The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to the
chassis open connector. Whenever a chassis component has been
removed, the sensor sends signal to the connector alerting you of a
chassis intrusion event.
Hardware Monitor for Windows
Install the “Hardware Monitor for Windows” utility. By default, the
chassis intrusion detection function is disabled. When enabled, a
warning message will appear when the chassis is open. The utility can
also be configured so that a beeping alarm will sound when the
chassis is open. Refer to the “Hardware Monitor for Windows” sec-
tion in chapter 4 for more information.
Chassis Open Connector
Ground
Chassis signal
1
2
X