User`s manual
Table Of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - Watchdog Sample Code
- Appendix B - System Error Message
- Appendix C - Troubleshooting
- Appendix D - NLITE and AHCI Installation Guide
28
2
Hardware Installation
Panel Power Select
JP13
2-3 On: 5V
1-2 On:
3.3V
(default)
312
312
X
JP13 is used to select the power supplied to the LCD panel.
Important:
Before powering-on the system, make sure JP13’s setting
matches the LCD panel’s specification. Selecting the incorrect
voltage will seriously damage the LCD panel.