User`s manual
Table Of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - Watchdog Sample Code
- Appendix B - System Error Message
- Appendix C - Troubleshooting
- Appendix D - NLITE and AHCI Installation Guide
26
2
Hardware Installation
JP5 is used to select the power of the PS/2 keyboard/mouse port.
Selecting 5V_standby will allow you to use the PS/2 keyboard or
PS/2 mouse to wake up the system.
BIOS Setting
Configure the PS/2 wake up function in the Integrated Peripherals
submenu (“Super IO Device” section) of the BIOS. Refer to chapter
3 for more information.
Important:
The 5V_standby power source of your power supply must sup-
port
≥
720mA.
PS/2 Power Select
1-2 On: 5V
(default)
2-3 On:
5V_standby
JP5
3
1
2
3
1
2
X