User`s manual
Table Of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - Watchdog Sample Code
- Appendix B - System Error Message
- Appendix C - Troubleshooting
- Appendix D - NLITE and AHCI Installation Guide
127
D
NLITE and AHCI Installation Guide
11. A warning message ap-
peared because the se-
lected SATA controller did
not match your hardware
device.
Ignore the warning and
click Yes to proceed.
12. Click Finish.
13. The system’s settings
have been changed. Win-
dows XP requires that
you restart the computer.
Click Yes.
14. EntertheBIOSutilityand
modify the SATA control-
ler from IDE to AHCI. By
doing so, Windows will
work normally with the
SATA controller that is in
AHCI mode.