User`s manual

Onboard Parallel Port

Parallel Port Mode

Supervisor Password

If you want to protect your system and setup from unauthorized entry,

set a supervisor’s password with the “System” option selected in the

BIOS Features Setup.

If you want to protect access to setup only, but not your system, set a

supervisor’s password with the “Setup” option selected in the BIOS Fea-

tures Setup. You will not be prompted for a password when you cold

boot the system.

Use the arrow keys to highlight the “Supervisor Password” option and

press <Enter>. The message below will appear.

Enter Password:

Type in the password. You are limited to eight characters. When done,

the message below will appear:

Confirm Password:

You are being asked to verify the password. Type in exactly the same

password. If you type in a wrong password, you will be prompted to

enter the correct password again.

Selects the I/O address and IRQ for the onboard parallel port.

Disables the onboard parallel port.

378H/IRQ7

3BCH/IRQ7

278H/IRQ5

Disabled

Selects the parallel port mode according to the type of printer

device connected to your onboard parallel port.

SPP

EPP

ECP

EPP/ECP