User`s manual

5
RAID
121
Step 2: Configure Serial ATA in the Award BIOS
1. Power-on the system then press <Del> to enter the main menu
of the Award BIOS.
2. Select the Integrated Peripherals submenu - OnChip IDE Device
section of the BIOS to configure SATA.
The settings on the screen are for reference only. Your version may not be
identical to this one.
IDE HDD Block Mode
IDE DMA Transfer Access
IDE Primary Master PIO
IDE Primary Master UDMA
On-Chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Master UDMA
SATA Mode
SATA Operating Mode
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Device
Item Help
Menu Level
XX
↑↓→←: Move Enter: Select F1: General Help+/-/PU/PD: Value F10: Save ESC: Exit
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Enabled
Enabled
Auto
Auto
Enabled
Auto
Auto
IDE
Native
If your IDE hard drive
supports block mode
Select Enabled for
automatic detection of
the optimal number of
block read/writes per
sector the drive can
support
3. Press <Esc> to return to the main menu of the BIOS setup
utility. Select “Save & Exit Setup” then press <Enter>.
4. Type <Y> and press <Enter>.
5. Reboot the system.