User's Manual
Table Of Contents
- ZALPHA 3.3 User Manual
- Copyright Notice
- Table of Contents
- Table of Figures
- Table of Tables
- 1. Preface
- 2. Safety
- 3. Getting Started
- 4. Product Presentation
- Section 1: About Zalpha
- Section 2: Modules of Zalpha
- Section 3: Safety Features
- Section 4: LED Indicators
- Section 5: Expansion IO
- Section 6: Main Features of Zalpha
- 5. Troubleshooting
- 6. Services and Maintenances
- 7. Disclaimer
- 8. Certification
- 9. Change Log
Product Presentation
41
www.dfautomation.com
ZALPHA 3.3 User Manual
Backup and Restore
1. Sensor profile can be saved and restore.
2. Click on the “save” icon to save the profile (As shown below). The file will be saved in (.arax)
format.
Figure 4-18: Save the Profile (.arax) to Local Drive
3. To restore the profile, just click File > Open, and select the .arax file that you wish to restore.
Then just execute “Write to sensor” to program the profile to the sensor
Figure 4-19: Load the Profile (.arax) from Local Drive
Profile Limitation
There are a few limitations in the creation of laser profile that user should take note:
• Max 31 laser profiles can be created
• Max area, radius 6m, 270 degree