Instructions / Assembly

22
TIPS: Before Beginning:
·Read and understand the instructions thoroughly.
·Check and make sure that all parts are present.
·For future reference,save this instruction sheet.
1. Locate the burner control knob and make sure it is in the "OFF" position.
2. Connect propane (LP) cylinder. (See above pages).
3. Open LP tank valve slowly.
4. Push igniter button to create sparks at the electrode and hold.
5. Push and turn burner control knob to the "LOW" position. Continue to push the
control knob for 5 secondsafter ignition.
6. If ignition does occur within 5 seconds, turn the burner control knob to "OFF", wait 5
minutes for gas to clear and repeat the lighting procedure. If burner still will not light,
refer to the Troubleshooting Section.
7. Once the appliance is lit, flame height can be changed by adjusting the burner control
knob between the "High" and "Low".
8. Always check burner flames periodically to ensure proper operation. Flames should be
mostly yellow with some blue for best performance(See diagram).
9. Inspect the burner every time before use, if there’s evident that the burner is
damaged, or the burner can not light, contact the manufacturer for replacement.
Improper lighting procedure will cause injury or damage
If the burner does not ignite with the burner control valve open, gas will continue to
flow out of the burner and could accidentally ignite which can cause injury or
property damage.
TO LIGHT