Operating instructions

PROGRAMMING INSTRUCTIONS:
Programming can be accomplished manually using the machine controls or by connecting to the
machine control using a PDA (personal digital assistant). For instructions on using a PDA with this
washer control, please contact your local Dexter distributor. Please read below for manual
programming instructions.
The washer has two levels of programming. The Coin/Price Programming allows the owner to set
the price for the washer features and the values of the coins. The Washer Cycle Programming allows
the owner complete access to the wash cycle parameters – add/remove a bath, bath times, spin times,
water temperatures, etc. To enter the programming modes, the top of the washer must be unlocked
and slid toward the back of the washer a few inches.
COIN PRICE PROGRAMMING
While the washer is in the Idle mode, push the Programming pushbutton on the controller. The Idle
mode is when the washer is not running a cycle and the price of the bath is displayed. The
Programming pushbutton is a very small button located on the upper center of the controller directly
behind the display. There are seven stages in the Coin/Price Programming mode.
Stage 1: Right Coin – The display will blink first a “r” indicating right coin and then a coin value
($1.00 – default). The display will blink back and forth between the “r” and the value. To change
the value, use the Hot temperature button to decrease and the Warm temperature button to increase.
The value will change in 1¢ steps. The range of values is from $00.00 to $99.99. When the desired
right coin value is displayed, push the Start button once to store the new value and a second time to
move to the next Coin/Price programming step.
To exit the Coin/Price programming mode, push the Cold temperature button for 5 seconds.
Stage 2: Left Coin – The display will blink first a “L” indicating left coin and then a coin value
($0.25– default). The display will blink back and forth between the “L” and the value. To change
the value, use the Hot temperature button to decrease and the Warm temperature button to increase.
The value will change in 1¢ steps. The range of values is from $00.00 to $99.99. When the desired
left coin value is displayed, push the Start temperature button once to store the new value and a
second time to move to the next Coin/Price programming step. To exit the Coin/Price programming
mode, push the Cold temperature button for 5 seconds.
Stage 3: Wash Price – The display will blink first a “P” indicating wash price and then present wash
price. The display will blink back and forth between the “P” and the price. To change the value, use
the Hot temperature button to decrease and the Warm temperature button to increase. The value will
change in 1¢ steps. The range of values is from $00.00 to $99.99. If the wash price is set to $00.00,
the display will show “FREE” after exiting the programming mode. When the desired price is
displayed, push the Start button once to store the new value and a second time to move to the next
Coin/Price programming step. To exit the Coin/Price programming mode, push the Cold temperature
button for 5 seconds.
To step through to the desired stage, repeatedly push the START button until the desired
stage is blinking on the display. To exit the Coin/Price programming mode, push and hold
the Cold temperature button for 5 seconds.