Operating instructions

WASH CYCLE PROGRAMMING
To change a feature of the wash cycle, push and hold the Hot temperature button and then push the
programming pushbutton on the controller. The Washer must be in the Idle mode to enter the Wash
Cycle Programming mode. When entering the cycle programming mode, the Bleach LED will start
to blink and continue to blink as long as you are in the Cycle Programming mode.
The display will show “C 0”. This is the default cycle number.
End of Cycle Alarm: The end of cycle alarm can be turned on or off by pushing the Hot or Warm
temperature buttons until “AL” is displayed and pressing the Start button. The display will now read
“on” or “off” and can be changed by pressing the Hot or Warm temperature buttons. When the
desired setting is displayed, press Start again to save.
Modifying the Wash Cycle: To change the wash cycle, push the Hot or Warm temperature buttons
until the display changes to “C 1”, indicating cycle one is selected. The temperature buttons are
used to make changes to the program. In the program mode, the buttons will do the following:
When the display shows “C 1”, push Enter. The display will show “b“ and the PreWash mode light
will blink. Use the Up/Down buttons to move to the bath that will be changed. As Up/Down
buttons are pushed, the next bath mode light turns on.
Note: The washer can be returned to the factory default settings by holding
the Start button and then pressing the Warm button. The display must
show “C 0” to do this. When the cycle default values are loaded, the
washer will automatically exit the programming mode.
Note: The Wash Cycle programming mode will automatically exit and return to
the Idle mode if no buttons are pushed for one minute.