User guide

OPERATING INSTRUCTIONS

1. Ensure that power is on to the washer.

2. Ensure that the ADVANCE/RUN/PROGRAM keylock is in the RUN position.

3. Load the clothes loosely in the cylinder and latch the door securely. Be

sure clothing does not get caught between the door gasket and tub front

when closing the door.

NOTE: To begin closing the door, the handle must be in the horizontal

position. After moving the door to the closed position, the

handle must be turned down to the vertical position in order

to latch the door for machine operation.

4. Select one of thirty cycles by using the SCROLL UP/SCROLL DOWN buttons to

change the number indicated in the two digit LED display. The selection

is made when the number indicated corresponds with the desired cycle.

5. If you are manually adding wash compounds, add low sudsing powdered

detergent in the amount shown below into the detergent compartment on top

of the machine. Location is illustrated on the black cover on the top of

the machine. This compartment will be flushed during the WASH segment of

the cycle. Rinse conditioners may be added to their own compartment if

desired. This compartment will be flushed during the FINAL RINSE segment

of the cycle.

POWERED

DETERGENT REQUIREMENT

THOROUGHBRED 600

1/3 to 1/2 CUP

Figure 8 - Recommended Detergent Quantity

6. If you wish to manually add bleach during the cycle, add bleach in the

round opening in the top of the machine. Location is illustrated on the

black cover on the top of the machine.

NOTE: Any additional washing compounds may be added at the appropriate

time by pouring into the round opening in the top.

7. Push the green START button to start the cycle.

The cycle time remaining is displayed throughout the cycle. The cycle

number in operation can to displayed by pushing and holding START, then

push SCROLL UP. The cycle number will be displayed as long as these two

buttons are depressed.

Soak - At any time during the cycle, the red STOP button can be depressed

to stop the washer. All washer cycle information is retained and the

door remains locked. The washer will soak the load for 15 minutes, then

agitate for 30 seconds. This will repeat until the cycle is started

again. This feature allows for an extended soak if required. The washer

cycle will continue when the START button is depressed.

The selected cycle can be cleared at any time by depressing and holding