User Manual

SPECIFICATIONS
MODEL T400 30LB WASHER
CAPACITY
CYLINDER SIZE
ELECTRICAL
DRIVE SYSTEM
WASH SPEED
INTERMEDIATE
EXTRACT
FINAL EXTRACT
MACHINE CONTROL
WATER INLET
DRAIN VALVE
30LBS/4 CUBIC FT. (13.6 kg/113 L)
25” DIA X 14 1/8” DEEP (63.5cm X 36cm)
208-240 VAC, 60 HZ, 1 OR 3 PHASE
SOFT START REVERSING INVERTER DRIVE, 2 HP MOTOR
50 RPM
412 RPM (60 G’S)
532 RPM (100 G’S)
PROGRAMMABLE COMPUTER WITH 6 STANDARD CYCLES.
2 SOLENOID OPERATED VALVES
FLOW RATE: 9 GAL/MIN EACH, 30-120 PSI
3” DIAMETER
STARTING THE WASHER
A. Load the clothes into the cylinder and latch the door securely. Be sure clothing does
not get caught between the door gasket and tub front when closing the door. Maximum
load is 30 pounds clothes, dry weight. Do not load the washer with more than 30lbs.
B. Select the appropriate cycle number (1 through 6 for the load being washed. See the
cycle descriptions in the programming section. Use the UP and DOWN keys to change
the cycle number.
C. If not using a chemical injection system, add low-sudsing powdered detergent into the
“detergent” compartment of the automatic dispenser on the top of the washer. If desired
add fabric softener to the “fabric softener” compartment. Use the amount of fabric
softener as recommended by the manufacturer.
If liquid wash products are used in the “detergent” compartment, they must be added at
the beginning of the wash cycle.
If the machine is set for pre-wash, washing products can be added to the round opening of
the dispenser or put in with the clothes when loading the cylinder before starting the
machine.
D. Press START. The display will go blank for a moment and then display the cycle
time in minutes. The clothes door will lock and remain locked until the end of the cycle.