Operator`s manual

2
TABLE OF CONTENTS
PAGE NO.
DRYER DIMENSIONS (Figure 1) .........................................................................3
UNCRATING .........................................................................................................4
DRYER INSTALLATION .......................................................................................4
DRYER EXHAUST SYSTEM (Figure 2) ...............................................................6
DRYER SHUTDOWN ...........................................................................................7
OPERATING INSTRUCTIONS.............................................................................8
PROGRAMMING INSTRUCTIONS ......................................................... 9, 10, 11
SERVICING DRYER...........................................................................................15
PREVENTATIVE MAINTENANCE .....................................................................15
WARNINGS ABOUT USE AND OPERATION
It is ABSOLUTELY ESSENTIAL that the dryer be grounded to a known earth (zero) ground. This is not only for
personal safety, but is necessary for proper operation of the controller. Failure to do so will void the warranty of the
controller.
KEEP SHIELDS, GUARDS AND COVERS IN PLACE. These safety devices are provided to protect everyone
from injury.
A DRYER SHOULD BE CONNECTED TO POWER FOR THREE (3) MINUTES before it is operated or before a
program change is made. Operation or program changes, which occur during this “power up” period, are subject to
loss in case of power interruption. After the initial three minutes, all programmed data is protected from power
interruptions of any length and the customer’s individual cycle is protected up to 3 seconds. This is done without
batteries.
LEAVE THE ELECTRICAL POWER TO THE DRYER ON AT ALL TIMES except when necessary for service or
other similar activities. The hour meter function adds only full hours to its reading. If the power is shut off every night,
any fraction of an hour of time that is on the machine at that time will be lost. Turning the power off every night could
also have some effect on the long-term life of the memory after a number of years. Turning power off occasionally
won’t affect the unit.
THIS DRYER IS EQUIPPED WITH AN OVER-TEMPERATURE THERMOSTAT located on the right side of the lint
hood assembly (open lower service door). Should the dryer cease to operate, refer to your “Service Procedure and
Parts Data” book for instructions.
CHECK THIS THERMOSTAT WHEN INSTALLING DRYER to assure it is not tripped. Impacts such as rough
handling in shipment, may trip the thermostat.