Operator`s manual

PROGRAMMING INSTRUCTIONS:

(To switch to program mode.)

1. Unlock and open the upper service door.

2. Open the loading door.

3. Push the Program Button found just to the left of the

WARM or LOW cycle light. The Button is accessible

through a hole in control mounting plate, after removal

of bright metal plug.

4. The control switches to PROGRAM mode. In PRO-

GRAM mode, the membrane switch keypad becomes

a 4-switch programming tool.

5. The ACTUAL NUMERICAL VALUES desired are keyed

in as explained on P.11.

HOT OR HIGH

PERM

PRESS

WARM OR LOW

START

PROGRAM

BUTTON

DOOR

SERVICE

DOOR

IMPORTANT: Please remember to push to actually enter (store in memory) new data. If you merely change the

display, memory hasn’t yet been changed -- only will actually change the memory!

START

DISPLAY

ANNUNCIATOR LIGHTS WHICH HELP

IDENTIFY PROGRAMMING STEPS

START: Stores the displayed value in memory,

and advances the controller to the

programming step.

INCREASES

DISPLAYED VALUES

ZEROS HOUR METER ON STEP 1

ZEROS COIN COUNT ON STEP 2

RESTORES ORIGINAL VALUE ON STEPS 3-14

DECREASES

DISPLAYED VALUES

TYPE 2 PROGRAMMING

MED.