Specification

DEXPAN (Non-Explosive Demolition Agent)
Section 8. Exposure controls/personal protection
Hand protection
Use a properly fitted, particulate filter respirator complying with an approved standard if
a risk assessment indicates this is necessary. Respirator selection must be based on
known or anticipated exposure levels, the hazards of the product and the safe working
limits of the selected respirator.
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts.
Eye/face protection
Respiratory protection
:
:
:
Body protection
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation.
Appropriate engineering
controls
:
Use only with adequate ventilation. If user operations generate dust, fumes, gas, vapor
or mist, use process enclosures, local exhaust ventilation or other engineering controls
to keep worker exposure to airborne contaminants below any recommended or statutory
limits.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period. Ensure
that eyewash stations and safety showers are close to the workstation location.
Hygiene measures
:
Individual protection measures
Skin protection
Other skin protection
:
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.
Mexico
Ingredient name
Calcium hydroxide
NOM-010-STPS (Mexico, 9/2000).
LMPE-PPT: 5 mg/m³ 8 hours.
Silica, vitreous
NOM-010-STPS (Mexico, 9/2000).
LMPE-PPT: 0.1 mg/m³ 8 hours.
Diiron trioxide
NOM-010-STPS (Mexico, 9/2000).
LMPE-CT: 10 mg/m³, (as Fe) 15 minutes.
LMPE-PPT: 5 mg/m³, (as Fe) 8 hours.
Aluminum oxide
NOM-010-STPS (Mexico, 9/2000).
LMPE-PPT: 10 mg/m³ 8 hours.
Exposure limits
Section 9. Physical and chemical properties
Physical state
Melting point
Solid. [Powder.]
1000°C (1832°F)
Odorless.
Odor
pH
Gray.
Color
Flash point
Not available.
Not available.
Not available.
Odor threshold
:
:
:
:
:
:
:
Appearance
Boiling point
:
Not available.
6/11
Tel : +1-888-GHS-7769 (447-7769) / +1-450-GHS-7767 (447-7767)
www.kmkregservices.com www.askdrluc.com www.ghssmart.com