Full Product Manual
Page 12 - Instruction
Please ALWAYS wear
Usage Instruction
Concrete Demolition and Rock Breaking has never been EASIER!
3 Easy Steps to SUCCEED: Drill, Mix & Fill
1) Drilling:
Use 1.5 inches (3.8 cm) drill bit, holes should be drilled 1 ft. (30 cm)
apart. 80-90% of the depth, do not go through. (Diagram 1)
* Using smaller drill bit will reduce Expanding Strength.
* Please call for applications with depths less than 6 inch.
2) Mixing:
In a bucket, combine 0.4 gallons (1.5 liters) of cold water with one
11 lb. (5 kg.) bag of Dexpan
®
. (Diagram 2)
Mix well to a slurry, no lumps. (a drill and paddle is recommended)
3) Filling:
Dexpan
®
slurry should be poured into holes within 10-15 minutes
after mixing. (Diagram 3)
Coverage:
Normally one 11 lb. (5 kg.) bag of Dexpan
®
can fill up to 9 lineal feet
(2.5 meters) of 1.5 inches (3.8 cm) diameter holes.
Cracking Or Breaking Time:
Properly mixed, the cracks may appear after 2~8 hours. Allow 24 hours
for best results. If Dexpan
®
completely dries into powder and did NOT
crack, pour additional water onto filled holes. DO NOT remove
Dexpan
®
from holes.
Warning! Improper use may cause serious injury
Important Safety Precautions and First Aid:
FORCEFUL BLOWOUTS may occur once mixed with water!
Keep a safe distance. DO NOT look directly into filled holes. Use of
Dexpan
®
in hot weather could increase chances of blowouts. DO
NOT pour into hot holes. Use iced water in summer.
Alkaline Burns may occur. DO NOT breathe in dust. AVOID eye
and skin contact. If eye or skin contact should occur , rinse it off
IMMEDIATELY with plenty of water for at least 20 minutes, and
consult doctor. Refer to SDS.
Choose correct type of Dexpan based on rock / concrete temperature.
Keep Dexpan
®
in DRY storage. Seal box / bag after use.
Keep out of reach of children and pets.
Rubber Gloves Safety Goggles Dust Mask
SDS (Safety Data Sheet) is
available upon request.
For technical support,
Please call 575-528-5454
(Se Habla Español)
Visit us at
www.Dexpan.com
®
1. Drill
2. Mix
3. Pour