User's Manual

70
PRECAUTION
Do not discard your transmitter. It is reusable. The same transmitter is used for each
session until you have reached the end of the transmitter battery life.
Do not remove the transmitter while the sensor pod is still attached to the body.
After the sensor pod is off your body, you must remove the transmitter to reuse it. Use either of these two
transmitter removal methods:
Method 1
The safety lock that you removed from the applicator (see Chapter 6, Section 6.4, Placing the Sensor),
can be used as a tool to remove the transmitter.
1. Place the sensor pod/transmitter on a flat surface.
2. Hold the rounded edge of the safety lock.
3. Make sure the jagged edge of the safety lock is facing down, with the arrow pointing up, as shown:
Method 2
Use your fingers to spread out the tabs at the back of the sensor pod (end closest to the sensor pod tab
wings). The transmitter will “pop” out of the sensor pod.