User's Manual

38 | Continuous Glucose Monitoring System

Remove the Adhesive backing Adhere the Sensor on the skin

Remove the Safety Lock/Transmitter Key

3.4 PLACING THE SENSOR

1. After you have cleaned your skin, remove the adhesive backing from the

Sensor Pod. Hold the Sensor by the plastic Applicator and try not to touch the

sticky adhesive patch.

2. Place the Sensor on the area. You can place the Sensor ﬂ at facing to the

left or right of your belly button. Make sure the Sensor is placed in the same

direction shown in the picture below. You should not place the Sensor pointing

in the up or down direction.

3. After placing the Sensor, press ﬁ rmly on and around the outside of the

adhesive patch to make sure it is ﬂ at.

a. Pressing the patch to remove any wrinkles should help it stick better.

b. Press ﬁ rmly over the entire patch area.

4. Hold on to the Applicator. Then pull the Safety Lock/Transmitter Key straight

out away from the applicator, in the direction the arrow shows below.