User's Manual

114 | Continuous Glucose Monitoring System
9
9.2.1.2 STATUS AREA SYMBOLS DURING BLOOD DROP
PROMPTS
If you are prompted repeatedly by the Double Blood Drop screen, Additional
Startup Blood Drop screen (1 checked), or the Single Blood Drop screen, make
sure you fi rst check the Status Area on your Receiver before you take another
fi ngerstick reading. Then follow the steps below:
1. Clear the prompt from the Screen by pressing any button on the Receiver.
2. Check the Status Area in the upper right corner of your Receiver. You will
decide what to do based on the symbol that is shown in the Status Area:
a. If the Double Blood Drop Prompt Symbol
is
displayed:
•
Take 2 more fi ngerstick readings if you are
prompted by the Double Blood Drop.
b. If the Additional Startup Blood Drop Prompt
Symbol
is displayed:
•
Take 1 more fi ngerstick reading if you are
prompted by the Additional Startup or Single
Blood Drop. (Readings must be within 40-400 mg/dL).0
c. If the “Single” Blood Drop Symbol
prompt is displayed:
•
Enter your fi ngerstick readings into the Receiver.
d. If
is displayed, your Receiver cannot
understand your Sensor signal. Do not take any
more fi ngerstick readings for calibration at this
time. Wait until you see one of the Blood Drop
Prompts and review Steps 1 and 2.
“Unknown Glucose
Reading” Symbol
Double Blood Drop
Prompt