Specifications

Internal public
LH-D-BBU-02
2017-5-8 Version:C
Bedding Division
Page 4 of 6
LED1:
When the pair code, set or restore the memory position,
corresponding flashing;
Other functions light up after pressing the button;
PAIR: flat + stop
1.AC power cycle, LED turns into blue stay in 20s.;
2.Press and hold "Flat" + "Stop" button for 4 sec, backlight
of remote flashes and begins pairing;
3.*If succeeds, the LED turns from blue to green within 20s,
the backlight of remote stops flashing;
*If fails, the LED turns from blue to green exceeds 20s,
the backlight of remote still flashes, then you need to repeat
steps 1-3;
Press and hold on for 5s, customize the current position to
the ZG position.
SET LOUNGE: flat + lounge
Press and hold on for 5s, customize the current position to
the lounge position.
MEMORY RESET: lounge + zg
Press and hold on for 2.5s, lounge position and ZeroGravity
position will be restored to the factory presets.
SET ZG: flat + zg
FCC Statement:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable
exposure condition without restriction.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The
device has been evaluated to meet general RF exposure requirement.
Le matériel est conforme aux limites de dose d'exposition aux rayonnements énoncés pour fac un autre
environnement. ce dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.