Technical data

ENGLISH
39
l. Menu/Power Button: Press
this button to power the unit on
(hold for 0.5 seconds) or off (hold
for 3seconds). When the unit is
powered on, press this button to view
the menu options.
m.
Photo Capture Button: Press this
button for taking a photo.
INTENDED USE
The imaging thermometer measures radiated energy
from an object’s surface and then uses those
measurements to display an image and estimate
temperature.
Photos can be taken and then saved (bitmap format)
on a micro SD card.
The imaging thermometer can be used for
inspections and trouble shooting of electrical
systems, HVAC, plumbing, mechanical equipment,
residential buildings or automotive systems.
The imaging thermometer is a professional tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
Electrical Safety
The charger has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
Your DEWALT charger is double insulated
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
DEWALT service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Always turn the imaging
thermometer off before inserting or
removing the battery pack.
WARNING: Use only DEWALT battery
packs and chargers.
Belt Hook (fi g. 3)
(Optional Accessory)
WARNING: To reduce the risk of
serious personal injury, DO NOT
suspend the imaging thermometer
overhead or suspend objects from
the belt hook. ONLY hang imaging
thermometer’s belt hook from a work
belt.
WARNING: To reduce the risk of
serious personal injury, ensure the
screw (n) holding the belt hook is
secure.
IMPORTANT: When attaching or removing the belt
hook, use only the screw that is provided.
The belt hook (o) can be attached to either side
of the tool using only the screw (n) provided, to
accommodate left- or right-handed users. If the
hook is not desired at all, it can be removed from
the tool.
To move belt hook (o), remove the screw (n) that
holds the belt hook in place then reassemble on the
opposite side.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
Inserting and Removing the
Battery Pack from the Imaging
Thermometer (fi g. 4)
NOTE: Make sure your battery pack is fully charged.