Technical data

ENGLISH
45
Report Writing Software
The imaging thermometer utilises report writing
software to produce professional reports. The
software can be downloaded from www.dewalt.eu
or www.2helpU.com.
To Turn Off Imaging Thermometer
1. To turn off the imaging thermometer, push the
menu/power button (l) and hold for 3 seconds.
The imaging thermometer will also automatically
turn off after 10 minutes of non-use.
2. Slide lens cover (g) up to protect lens when not
in use.
Operating Tips
• Use only DEWALT 10.8 V lithium-ion battery.
• Ensure the DEWALT battery is in good working
condition.
• Avoid sudden changes in temperature such
as when entering or leaving a heated building
on a cold day as this can cause condensation
inside the imaging thermometer. To prevent
condensation, place the imaging thermometer
in the kitbox or a plastic bag before exposing it
to sudden changes in temperature.
MAINTENANCE
Your DEWALT imaging thermometer has been
designed to operate over a long period of time with
a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and
regular cleaning.
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Cleaning
WARNING: Blow dirt and dust off with
clean, dry air at least once a week. To
minimize the risk of eye injury, always
wear proper eye protection when
performing this.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
WARNING: Do not apply solvents to
the lens as this may cause damage. Do
not clean the infrared lens too vigorously
as this can damage the delicate anti-
reflective coating.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
Optional Accessories
WARNING: Since accessories, other
than those offered by DEWALT, have
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only DEWALT recommended
accessories should be used with this
product.
RECOMMENDED ACCESSORIES
Consult your dealer for further information on the
appropriate accessories.
Troubleshooting
• Make sure the lens cover (g) is open.
• Make sure the 10.8 V battery is charged.
• Make sure the battery is installed on the handle
set when in use.
• If the screen freezes, remove the 10.8 V battery
pack to reset the unit. Reinsert the battery pack
and press the power on button.
KEY NOTES IF HAVING TROUBLE TAKING MEASUREMENT
1. Make sure to apply masking tape or flat black
paint to surfaces that are highly reflective (use
the default 0.95 emissivity setting).
2. Make sure to have the correct emissivity for the
material you are testing. Refer to Emissivity
and Nominal Emissivity Table.
3. Clean the material before testing if there is
heavy dirt, grease, etc.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.