Full Product Manual

ENGLISH
3
NOTICE: No dust tank are included in product.
CLEANING
To keep the poly tank looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.
Screw holes
Drum lid
Screw holes
Screw holes
TROUBLESHOOTING
PROBLEM SOLUTION
Dust separates not
separating well.
Air leak. Check cyclone
ange / drum lid / barrel.
Even small leaks will affect
performance.
Vacuum lter clogged.
Blockage in hose.
Air leak in bottom of cyclone
/ drum lid or dust drum.
Temporarily cut off airow to
allow the materials to drop
into the tank and then
restart.
Material swirls in
cyclone and won’t
drop down into
drum.
Use only DEWALT
recommended ttings.
Low air volume.
Hose connections
not tight.
NOTICE: Minor problems often can be
xed without calling customer service.
Air Inlet
Air Outlet
99.5%
of debris in the airstream
UP TO
SEPARATES & CAPTURES
WET/DRY
VACUUM
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
WARNING:
The dust separator contains a lter feature. It has
the capability to inlet sawdust and other debris. It
can be used to inlet dust and debris out of garages
or off patios and driveways. Follow the steps below
to use the dust separator with dust tank.
1. Insert the vacuum’s hose end into outlet of dust
separator, the hose should be snapped into place.
2. Locate inlet port on the dust separator.
3. Insert one end of the 1-7/8” x 7 ft. hose into the
inlet port.
4. Plug the power cord of the vacuum into an
appropriate outlet.
5. Press the switch on the vacuum to the "ON "
position.
To reduce the chance of re
hazard, empty dust tank after each use.
BEFORE USING THIS ACCESSORY, READ
AND UNDERSTAND THE INSTRUCTION
MANUAL THAT CAME WITH THE VACUUM