Use and Care Manual

ENGLISH
19
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
7 Choke lever in the CHOKE position on a hot engine or an
engine that has been exposed to thermal heat for a long
period of time.
Move choke to the NO CHOKE po si tion.
8 Fuel valve CLOSED. Move the fuel valve lever to the OPEN position.
9 Spray wand not in high pressure. See Spray Wand Nozzles under Operation.
10 Low water supply. Water supply must be at least 5 GPM @ 20 psi (138 kPa).
11 Leak at high pressure hose fitting. Repair leak. Apply sealant tape if necessary.
12 Nozzle obstructed. See Nozzle Cleaning under Maintenance.
13 Water filter screen clogged. Remove and clean filter. See To Clean the Water Inlet Filter
under Maintenance.
14 Air in hose. Turn off the engine, then the water source. Disconnect the
water source from the pump inlet and turn the water source
on to remove all air from the hose. When there is a steady
stream of water present, turn water source off. Recon nect
water source to pump inlet and turn on wa ter source. Squeeze trigger to
re move re main ing air.
15 Choke lever in the CHOKE position. Move choke to the NO CHOKE po si tion.
16 High pressure hose is too long. Use high pressure hose under 100 feet (30.48 m). Lengthen water supply
hose instead of high pressure hose.
17 Spray wand not in low pressure. See Spray Wand Nozzles under Operation.
18 Chemical filter clogged. Clean filter.
19 Chemical screen not in cleaning solution. Make sure end of chemical hose is fully submerged into cleaning solution.
20 Chemical too thick. Dilute chemical. Chemical should be the same consistency as water.
21 Worn seal or packing. Have parts cleaned or replaced by authorized service center.
22 Chemical build up in chemical injector. Have replaced by an authorized service center.
23 Worn or obstructed valves. Have replaced by authorized service center.
24 Worn unloader piston. Have replaced by authorized service center.
25 Worn or broken o‑ring. Check and replace.
26 Loose hose connection. Tighten.
27 Piston packings worn. Have replaced by authorized service center.
28 Pump head or tubes damaged from freezing. Have replaced by authorized service center.
29 Engine start connector is not connected. Connect engine start connector.
30 Battery is not charged. Charge the battery. See Charging the Battery under Maintenance.
31 Battery positive and negative battery wires disconnected. Connect the positive and negative battery wires.
32 Unit equipped with water sensing device. Presence of
water is not detected in the pump.
Turn water faucet completely on.