Manual

English

NOTICE: Risk of property damage. NEVER turn water supply off while

pressure washer engine is running or damage to pump will result.

4. Turn water source off.

5. Pull trigger on spray gun to relieve any water pressure in hose or

spray gun.

6. Refer to Storage for proper storage procedures.

MAINTENANCE

WARNING: Risk of burn hazard. When performing maintenance,

you may be exposed to hot surfaces, water pressure or moving parts

that can cause serious injury or death.

WARNING: Risk of fire hazard. Always disconnect, spark plug wire,

let the engine cool and release all water pressure before performing

any maintenance or repair. The engine contains flammable fuel. Do

not smoke or work near open flames while performing maintenance.

To ensure efficient operation and longer life of your pressure washer,

a routine maintenance schedule should be prepared and followed.

If the pressure washer is used in unusual conditions, such as high-

temperatures or dusty conditions, more fre quent maintenance checks

will be required.

Engine

Consult the Engine Owner's Manual for the man u fac tur er's

recommendations for any and all maintenance.

NOTE: The engine drain plug is located at the rear of the unit.

Pump

The pump was filled with oil at the factory. The pump on this unit is

maintenance free and requires no oil. If there is a problem with the

pump contact us at AUST 1800 841 749 / NZ 0800 467 813.

Nozzle Cleaning

If the nozzle becomes clogged with foreign materials, such as dirt,

excessive pressure may develop. If the nozzle becomes partially

clogged or restricted, the pump pressure will pulsate. Clean the nozzle

immediately using the following instructions:

1. Shut off the pressure washer and turn off the water supply.

2. Pull trigger on gun handle to relieve any water pressure.

3. Disconnect the spray wand from the gun.

4. Remove the high pressure nozzle from the spray wand. Remove

any obstructions with nozzle cleaning tool (Y) and back flush with

clean water.

FIG. 20 FIG. 21

5. Direct water supply into spray nozzle to back flush loosened

particles for 30 seconds.