SDS

SAFETY DATA SHEET
According to OSHA Hazard Communication Standard, 29 CFR
1910.1200
TTF-SB
Version
5.2
Revision Date:
09/22/2020
SDS Number:
800001027253
Print Date: 09/23/2020
Date of last issue: 06/18/2016
5 / 16
Packaging material
:
Suitable material: For containers or container linings, use mild
steel or high density polyethylene.
Unsuitable material: PVC.
Container Advice
:
Polyethylene containers should not be exposed to high tem-
peratures because of possible risk of distortion.
SECTION 8. EXPOSURE CONTROLS AND PERSONAL PROTECTION
Components with workplace control parameters
Components
CAS-No.
Value type
(Form of
exposure)
Control parame-
ters / Permissible
concentration
Basis
Oil mist, mineral
Not Assigned
TWA (Mist)
5 mg/m3
OSHA Z-1
Oil mist, mineral
TWA (Inhal-
able particu-
late matter)
5 mg/m3
ACGIH
Biological occupational exposure limits
No biological limit allocated.
Monitoring Methods
Monitoring of the concentration of substances in the breathing zone of workers or in the general
workplace may be required to confirm compliance with an OEL and adequacy of exposure con-
trols. For some substances biological monitoring may also be appropriate.
Validated exposure measurement methods should be applied by a competent person and sam-
ples analysed by an accredited laboratory.
Examples of sources of recommended exposure measurement methods are given below or con-
tact the supplier. Further national methods may be available.
National Institute of Occupational Safety and Health (NIOSH), USA: Manual of Analytical Meth-
ods http://www.cdc.gov/niosh/
Occupational Safety and Health Administration (OSHA), USA: Sampling and Analytical Methods
http://www.osha.gov/
Health and Safety Executive (HSE), UK: Methods for the Determination of Hazardous Substanc-
es http://www.hse.gov.uk/
Institut für Arbeitsschutz Deutschen Gesetzlichen Unfallversicherung (IFA) , Germany
http://www.dguv.de/inhalt/index.jsp
L'Institut National de Recherche et de Securité, (INRS), France http://www.inrs.fr/accueil
Engineering measures
:
The level of protection and types of controls necessary will
vary depending upon potential exposure conditions. Select
controls based on a risk assessment of local circumstances.
Appropriate measures include:
Adequate ventilation to control airborne concentrations.
Where material is heated, sprayed or mist formed, there is
greater potential for airborne concentrations to be generated.
General Information:
Define procedures for safe handling and maintenance of
controls.