SDS
MTD 4-CYCLE SMALL ENGINE OIL HD SAE 30 October 10, 2018
Page 9 of 9
Section 16. Other Information
NFPA Rating:
Health Hazard – 0
Flammability – 1
Instability/Reactivity – 0
HMIS Rating:
Health Hazard – 0
Flammability – 1
Physical Hazards – 0
(NFPA & HMIS Hazard Rating Key: 0 - Minimum Hazard; 1 - Slight Hazard; 2 - Moderate Hazard; 3 - High Hazard; 4 - Extreme
Hazard; * - Chronic Hazard Indicator, & PPE - Personal Protective Equipment Index A to L. These values are obtained using the
guidelines or published evaluations prepared by the National Fire Protection Association (NFPA) or the National Paint and Coating
Association (for HMIS or Hazardous Material Identification System).
Key to abbreviations
OSHA = Occupational Safety and Health Administration
ACGIH = American Conference of Industrial
Hygienists
ATE = Acute Toxicity
Estimate
BCF = Bioconcentration
Factor
CAS Number = Chemical Abstracts Service Registry
Number
cSt = Centistroke (mm2/s)
GHS = Globally Harmonized System of Classification and
Labeling of
Chemicals
IATA = International Air Transport
Association
IBC = Intermediate Bulk
Container
IMDG = International Maritime
Dangerous
Goods
LogPow = logarithm of the octanol/water partition
coefficient
OEL = Occupational Exposure
Limit
SDS = Safety Data
Sheet
STEL =Short term exposure
limit
TWA = Time weighted
average
UN = United
Nations
UN Number = United Nations Number, a four digit number assigned by
the
United
Nations Committee of Experts on the Transport of Dangerous
Goods.
Prepared By: OMNI Specialty Packaging EH&S Department
Revision Date: October 10, 2019
Status: Final
Revision Note: Revision 002 – Reviewed and update.
Disclaimer
All reasonably practicable steps have been taken to ensure the information provided in this Safety Data Sheet is correct to the
best of our knowledge, information and belief at the date of its publication. The information given is designed only as guidance
for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or
quality specification. The information relates only to the specific material designated and may not be valid for such material
used in combination with any other materials or in any process, unless specified in the text. This information is furnished upon
condition that the person receiving it shall make their own determination of the suitability of the material for their particular
purpose.
End of Safety Data Sheet