Use and Care Manual

English

tered air at an item that could be damaged by moisture. Some air

tools and accessories may require ltered air. Read the in struc tions

for the air tools and accessories.

How to Start

1. Turn the Auto/Off switch to “Auto” and allow tank pressure to

build. Motor will stop when tank pressure reaches “cut-out”

pressure.

2. Pull the regulator knob out and turn clockwise to increase pres-

sure. When the desired pressure is reached push knob in to

lock in place.

IMPORTANT: When using regulator and other accessories refer

to the manufacturers instructions.

WARNING: Risk of bursting. If any unusual noise or vibration is

noticed, stop the compressor immediately and have it checked by a

trained service technician.

The compressor is ready for use.

Shut-down (Fig. 1)

1. Move Auto/Off switch to the OFF position. NOTE: If finished

using compressor, follow Steps 2 - 6.

2. Pull the regulator knob out and turn counterclockwise until fully

closed. Ensure regulated pressure gauge reads 0 psi. Push

knob in to lock in place.

3. Remove hose and accessory.

WARNING: Risk of unsafe operation. Firmly grasp air hose in hand

when installing or disconnecting to prevent hose whip.

4. Drain the air tank,

see Draining Air Tank under Maintenance

Ensure air tank pressure gauge reads 0 psi.

WARNING: Risk of bursting. Drain air tank daily. Water will

condense in air tank. If not drained, water will corrode and weaken

the air tank causing a risk of air tank rupture.

5. Allow the compressor to cool down.

6. Wipe air compressor clean and store in a safe, non-freezing

area.

OPEN

FIG. 3

OFF

AUTO