Instruction manual

on days when the humidity is low. This is a harmless phenomenon but you are invited to bring the

tool to a D

WALT service center where it can be checked to assure that no electrical malfunction

is present.

MAINTENANCE

Your D

WALT power tool has been designed to operate over a long period of time with a minimum

of maintenance. Continuous satisfactory operation depends upon proper tool care and regular

cleaning.

WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect

tool from power source before making any adjustments or removing/installing

attachments or accessories. Before reconnecting the tool, depress and release the

trigger switch to ensure that the tool is off.

Cleaning

WARNING: Blow dirt and dust out of all air vents with dry air at least once a week. Wear proper

ANSI Z87.1 (CAN/CSA Z94.3) eye protection and proper NIOSH/OSHA/MSHA respiratory

protection when performing this.

WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of

the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth

dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse

any part of the tool into a liquid.

Lubrication

WALT tools are properly lubricated at the factory and are ready for use. Tools should be

relubricated regularly every sixty days to six months, depending on usage. (Tools used constantly

on production or heavy-duty jobs and tools exposed to heat may require more frequent lubrication.)

This lubrication should only be attempted by trained power tool repairpersons such as those at

WALT service centers or other authorized service locations.

Motor Brushes

Be sure tool is unplugged before inspecting brushes. Carbon brushes should be regularly inspected

for wear. To inspect brushes, unscrew the plastic brush inspection caps (located in the sides of the

motor housing) so the spring and brush assemblies may be withdrawn from the tool. Keep brushes

clean and sliding freely in their guides. Carbon brushes have varying symbols stamped into them,

and if the brushes are worn down to the line closest to the spring, they must be replaced.

DeWalt electric

Power tools