® DW682K
4 3 2 6 11 1 5 8 7 A 10 9
2 9 4 6 1 B C1 11 8 C2 D 6 7 F E 12 G H
10 J K1 14 K2 13 5 5 15 L 5 cm 5-7.
P N4 5-7.
S2 T U1 U2 U3 U4 V1 V2
V3 V5 V4
ENGLISH BISCUIT JOINTER DW682K Congratulations! You have chosen a DEWALT Power Tool. Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional Power Tool users. Take appropriate measures for the protection of hearing if the sound pressure of 85 dB(A) is exceeded.
ENGLISH 11 Do not overreach Keep proper footing and balance at all times. 12 Avoid unintentional starting Do not carry the plugged-in tool with a finger on the switch. Be sure that the switch is released when plugging in. 13 Stay alert Watch what you are doing. Use common sense. Do not operate the tool when you are tired. 14 Disconnect tool Shut off power and wait for the tool to come to a complete standstill before leaving it unattended.
ENGLISH • The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Attach the wires to their respective points in the plug (see below). Brown is for Live (L) (2) and Blue is for Neutral (N) (4). • Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Never use a light socket.
ENGLISH Dustbag • Insert the straight adapter (13) into the dust extraction outlet (5). • Attach the dustbag (15) to the adapter. • Whenever possible, connect a dust extraction device designed in accordance with the relevant regulations regarding dust emission. Instructions for use Always observe the safety instructions and applicable regulations. Switching ON and OFF (fig. B) • To run the tool, press the ON/OFF-switch (1).
ENGLISH • Clamp the workpiece and align the tool as shown (fig. U4). • Cut the biscuit slots as described above. T-joints (fig. V1 - V5) This type of joints is commonly used to attach shelves to side panels (fig. V1). • Place the workpieces on a flat surface as they are to be assembled (as an upside down T). • Mark the biscuit centres on the shelf piece. • Lightly mark the top of the shelf on the side panel (fig. V2).
