Technical data

9
E N G L I S H
)A .gif( ekorts muludnep eht gnitteS
a seetnaraug ekorts muludnep elbatsujda ehT
perfect cutting stroke for different materials.
Slide the selector (10) to the desired position
referring to the table below. The selector can be
manipulated during operation.
Pos. Wood Metal Plastics
2 Fast cuts - PVC
2 Thick workpieces - Fibreglass
Acrylic
1 Plywood Aluminium -
Chipboard Non-ferrous -
0 Thin workpieces Sheet metal -
Fine cuts
•
•
revoc eohs hctarcs-itna citsalp eht gnitnuoM
(fig. D)
egamad secuder )21( revoc eohs hctarcs-itna ehT
to the surface of (sensitive) workpieces.
Click the cover onto the shoe as shown.
•
•
•
•
•
•
•
Instructions for use
Always observe the safety instructions
and applicable regulations.
Make sure your workpiece is well secured.
Remove nails, screws and other
fasteners that may damage the blade.
Check that there is sufficient space for
the blade underneath the workpiece.
Do not cut materials that exceed the
maximum cutting depth of the blade.
Use sharp saw blades only. Damaged
or bent saw blades must be removed
immediately.
Do not use the tool for sawing pipes or
tubes.
Never run your tool without a saw blade.
For optimal results, move the tool
smoothly and constantly over the
workpiece. Do not exert lateral pressure
on the saw blade.
•
•
Keep the shoe flat on the workpiece
and lead the cord away in line with the
tool. When sawing curves, circles or
other round shapes, push the tool
gently forward.
Wait until the tool has come to a standstill
before removing the saw blade from the
workpiece. After sawing the blade may
be very hot. Do not touch.
)A .gif( ffo dna no gnihctiwS
DW341(K)
To run the tool, press the on/off switch (1).
For continuous operation, press and hold down
the switch (1), press the lock-on button (2) and
release the switch.
To stop the tool, release the switch.
To stop the tool in continuous operation, press
the switch briefly and release it. Always switch
off the tool when work is finished and before
unplugging.
•
•
•
•
Setting the electronic sawing speed (fig. E)
E) .gif(1(K)43WD
detrexe erusserp eht htiw seirav deeps gniwas ehT
on the on/off switch (1).
To preset the sawing speed, turn the control dial
(3) to the desired level. The higher the rate, the
higher the sawing speed. The required setting
depends on the thickness and kind of material.
Use high speeds for sawing soft materials such
as wood. Use low speeds for sawing metal.
Holding the tool (fig. F)
Hold the tool as shown.
F .gif :1(K)43WD -
•
•
•
Sawing in wood
If necessary, draw a cutting line.
Switch the tool on.
Hold the tool against the workpiece and follow
the line.
For sawing parallel to the edge of your workpiece,
install the parallel fence (optional) and guide your
jigsaw along the workpiece a shown in ì gure G.
•
•
•
•