® DW006
3 6 2 7 1 4 8 5 9 9 10 11 A 12
13 B 4 C 14 D E
ENGLISH CORDLESS PERCUSSION DRILL/DRIVER DW006 Congratulations! You have chosen a DEWALT Power Tool. Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional Power Tool users. Fuses: Europe U.K.
ENGLISH Director Engineering and Product Development Horst Großmann DEWALT, Richard-Klinger-Straße 40, D-65510, Idstein, Germany Safety instructions When using Power Tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and personal injury. Read the following safety instructions before attempting to operate this product. Keep these instructions in a safe place! General 1 Keep work area clean Cluttered areas and benches can cause accidents.
ENGLISH 16 Remove the battery pack Remove the battery pack when not in use, before servicing and when changing accessories. 17 Have your tool repaired by an authorized DEWALT repair agent This Power Tool is in accordance with the relevant safety regulations. To avoid danger, electric appliances must only be repaired by qualified technicians.
ENGLISH Your DEWALT charger is double insulated in accordance with EN 50144. Mains plug replacement (U.K. & Ireland only) • Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. • Disconnect the plug from the supply. • Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet.
ENGLISH Refresh mode (fig. A) The refresh mode helps to maintain the optimum capacity of the battery pack. It is therefore recommended to use the refresh mode weekly or every 10 charge/discharge cycles. Please make sure to use the feature whenever you notice decreased battery pack performance. • Start the charging process as described above. • Press the refresh mode button (12). The red charging indicator will stop blinking momentarily, quickly blink three times and then resume blinking as before.
ENGLISH • Rotate the side handle to the desired position and tighten the handle. Instructions for use • Always observe the safety instructions and applicable regulations. • Be aware of the location of pipework and wiring. • Apply only a gentle pressure to the tool. Excessive force does not speed up drilling but decreases tool performance and may shorten tool life. • To minimise stalling on break-through, progressively reduce the drill point pressure towards the end of the operation.
ENGLISH Environment GUARANTEE • 30 DAY NO RISK SATISFACTION GUARANTEE • Rechargeable battery pack This long life battery pack must be recharged when it fails to produce sufficient power on jobs which were easily done before. At the end of its technical life, discard it with due care for our environment: • Run the battery pack down completely, then remove it from the tool. • NiCd and NiMH cells are recyclable. Take them to your dealer or a local recycling station.
