Specifications

183
MAMARONECK
New York
Ph: 914-777-3245
Fx: 914-777-3875
ISLANDIA
Long Island
Ph: 631-234-0740
Fx: 631-234-0686
BENSALEM
Pennsylvania
Ph: 215-244-1545
Fx: 215-244-1082
POWER TOOLS
& ACCESSORIES
ANCHORING
POWER TOOLS
& ACCESSORIES
FASTENERS
CONTRACTOR
SUPPLY
ADHESIVES
& SEALANTS
DRYWALL SUPPLY
& HAND TOOLS
AIR & GAS
NAILERS
KS-23AM
KD-440
KD-200
KD-442
D-HANDLE PLUNGE MASTER SAW
The KS-23AM allows you to cut any desired depth through soft, rigid sheets and
panels from zero to full 3/8” depth with 2” diameter and 5/8” with 2-1/2”
diameter high-speed steel saw blades. This saw handles mild steel to 16 gauge;
aluminum to 3/16”; and plastics to 1/2”. Cuts are smooth and straight, so edges
do not need nishing. Powered by a “D” handle, heavy duty industrial type 3/8”
capacity 5.5 amp electric motor, the KS-23AM can handle the toughest jobs in the
shop or at the job site.
14 GAUGE POWER SHEAR
This lightweight, pistol-grip shear cuts 14 gauge mild steel and most grades of
stainless to 18 gauge. Double-insulated, the KD-440 cuts at over 150 inches per
minute, leaving a clean, at sheet, ready to fabricate. Distortions are absorbed in
an easily disposed of waste curl, leaving the sheet cool and free of burn, chips and
burrs. The cutting blades are nest high-speed steel, which you can easily replace
individually or in replacement blade kit #106.
PORTABLE POWER SAW AND SHEARS
16 GAUGE VARIABLE-SPEED SHEAR
The KD-442 variable speed shear easily cuts through 16 gauge mild steel and
stainless to 18 gauge. The steel shear head has close cutting heavy duty blades that
quickly cut through sheet metal, spiral pipe, metal doors and metal studs. Double
cutting action provides maximum sheet usage without burring or buckling the
material.
18 GAUGE POWER SHEAR
These double-cut shears feed quickly and quietly, without warping or bending your
nished piece (distortion is in the waste strip). It easily follows a scribed line - edges
are not hardened or burred, so you get maximum use of a sheet. The swiping action
of blades seals the edge of coated metals. These shears cut sheet metal up to 18
gauge in straight or contour lines at 180 inches per minute and plastic or Formica up
to 3/32” thick.
Cat. No. Motor Cutting Capacity Max RPM Power Source Length Weight
KS-23AM 253-10 16 ga. mild steel / 1/2” plastic 1,500 120v / 5.5 amp 18” 12 lbs.
KD-440 253-59 14 ga. mild steel / 16 ga. stainless 2,500 120v / 5.0 amp 14-1/2” 5 lbs.
KD-442 253-59 16 ga. mild steel / 18 ga. stainless 2,500 120v / 5.0 amp 14-1/2” 5 lbs.
KD-200 253-55 18 ga. mild steel / 20 ga. stainless 2,500 120v / 5.0 amp 14” 4 lbs.