Use and Care Manual

ManualsBrandsDEWALT ManualsTools & Hardware12-Volt Max 5.8 mm Inspection Camera with Wireless Screen Kit

The screen can be turned on and viewed when it is not attached to the

handle set, allowing easier maneuverability of the camera.

Camera

Cable (Fig. 5)

Align the camera cable with the camera connector (D). Push in and

turn the connector counterclockwise (camera screen facing you) to

firmly attach.

To remove the camera cable, turn the connector clockwise (direction

of arrow).

Additional camera cable and extensions are available at additional

cost. Please contact

DEWALT

Industrial Tool Co., 701 East Joppa

Road,

Baltimore, MD 21286, call

1-800-4-DEWALT

(1-800-433-9258)

or visit our website www.dewalt.com.

Hook

and Magnet DCT410 (Fig. 6)

The hook is beneficial for retrieving cable or wire located in tight

spaces. The magnet is beneficial for retrieving metal objects in tight

spaces.

To attach the hook or magnet, turn the knurled part of the camera

counterclockwise until it stops. .

Align the hook or magnet with the gray groove (T) then slide it down

until the tabs (U) at the top of the hook/magnet are securely In the

notches (V) located in the camera lens.

Turn the knurled part clockwise to lock the base of the hook and

magnet.

Hook,

Magnet and Mirror DCT411

(Fig. 7, 8)

Follow the process below to assemble the hook, magnet or mirror

onto the DGT411 9 mm camera.

I.With

the sleeve (W) on the accessory, insert the bottom of

accessory (bent wire) into the hole (X) in the 9 mm camera cable.

Make sure the accessory Is in the groove (Y) on the sleeve

and slide the sleeve onto the camera until the sleeve covers

the hole (X).

FIG.

ACAUTION:

Cut

Hazard.

Use care when handling

hook.

Belt

Hook (Fig. 9)

(Optional

Accessory)

AWARNING: To reduce the risk of serious personal

Injury,

NOT suspend tool overhead or suspend objects from the belt

hook.

ONLY hang tool's belt hook from a work

belt.

AWARNING: To reduce the risk of serious personal

injury,

ensure the screw (Z) holding the belt hook is

secure.

IMPORTANT: When attaching or FIG. 9

removing the belt hook, use only

the screw (Z) that is provided.

The belt hook (AA) can be be

attached to either side of the tool

using only the screw (Z) provided,

to accommodate left- or right-

handed users. If the hook is not

desired at all, it can be removed from the

tool.

To move belt hook, remove the screw (Z) that holds the belt hook In

place then reassemble on the opposite side.

OPERATION

Installing

and Removing the Battery Pack

(Fig. 10)

NOTE:

Make sure your battery pack is fully charged.

To install the battery pack (A) into the tool handle, align the battery with

the rails Inside the tool's handle and slide it firmly Into the handle until

you hear the lock snap into place.

FIG.

To remove the battery pack from the

tool,

press the release button (BB)

and firmly pull the battery pack out of the tool handle. Insert it into the

charger as described in the charger section of this manual.

Getting

Started

INITIAL SETUP

Language Setup

Press the forward or back arrow to select English, French or

Spanish.

Engilsh

French

Spanish