Use and Care Manual

ENGLISH
8
Fig.B
7
6
8
20
Fig.C
24
24
4
23
Attaching the Auxiliary Handle (Fig. A, C)
1. Place the auxiliary handle
4
on top of the handle base
23
so the upper trimmer pole
15
is between them.
2. Hold the auxiliary handle in place and slide the handle
bolts
24
into the handle from the top, threading them
into the handlebase.
3. Tighten the handle bolts with the supplied hex wrench .
Ensure the handle is securelyattached.
OPERATION

WARNING: To reduce the risk of
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can causeinjury.
Attaching Guard (Fig. D, E)

WARNING: Never remove the guard.
Damage or personal injury couldresult.

WARNING: NEVER OPERATE
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
The guard must always be properly attached on the
appliance to protect theuser.
1. Assemble the guard
9
to the motor housing
5
.
2. Using a crosshead screwdriver, insert the 2 guard screws
21
and tighten securely.
NOTE: An extended coverage guard is available (sold
separately) for extra coverage if desired. Use replacement
guard Part Number N776035.
Fig.D
5
Fig.E
21
9
Installing and Removing the Battery Pack
(Fig. F)
NOTE: For best results, make sure your battery pack is
fullycharged.
To install the battery pack
12
into the tool handle, align the
battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does notdisengage.
To remove the battery pack from the tool, press the release
button
13
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of thismanual
the pole completely until the guard
9
securely locks
into place over the rear of the battery housing
11
.