Manual

Thisoscillatingmulti-toolisaprofessionalpowertool.DONOTlet

childrencomeintocontactwiththetool.Supervisionisrequiredwhen

inexperiencedoperatorsusethistool.

ASSEMBLY AND ADJUSTMENTS

A WARNING: To reduce the risk of serious personal injury,

turn tool off and remove the battery pack before making any

adjustments or removing/installing attachments or accessories.

An accidental start-up can cause injury.

A WARNING: Risk of lacerations or burns. Do not touch the

sharp edges of accessories at any time. Do not touch workpiece

or blade immediately after operating the tool. They can become very

hot. Handle carefully.Always allow accessories and workpiece to

cool before handling.

installing/Rernovin9 Accessories

(Fig. 3-5)

TOOL-FREE ACCESSORY CLAMP

The DC3355 features a quick change accessory system. This allows

for faster accessory changes without the need for wrenches or hex

keys like other oscillating tool systems.

1. Grasp the tool and squeeze the FIG._

accessory clamping lever (C) as

shown in Figure 3.

2. Clean any residual debris from the

tool shaft and the accessory holder.

3. Slide the accessory between the

shaft (J) and the accessory holder

making sure the accessory engages

all eight pins on the holder and is

flush with the shaft.

4. Release the accessory clamp lever.

NOTE: Some accessories, such as scrapers and blades, can be

mounted at an angle if required as shown in Figure 5.

FIG.4 FIG.5

INSTALLING/REMOVING SANDING SHEETS (FIG. 6)

A diamond shaped platen uses a hook FIG.6

and loop adhesion system to attach the

sanding sheets. The platen allows you L

to use it on large flat surfaces and tight

spots or corners.

1. Attach the sanding platen (K) as

described under Installing/

Removing Accessories.

2. Align the edges on the sanding

sheet, with the edge of the sanding

platen and press the sanding sheet

(L) onto the platen.