Warranty

Shingle Guide (Fig. 8, 9)
Adjust shingle guide (H):
1. Loosen the adjusting screw (N) and slide the guide (H) to desired
position.
FIG. 8
H
N
2. Tighten adjusting screw firmly.
The guide (H) can be used as an aid to position the shingle being
nailed a specific distance (O) from the front edge of the previous row
of shingles (Q) as shown.
FIG. 9
H
Q
O
Clearing a Jammed Nail (Fig. 1, 10)
WARNING: Disconnect air line from tool and remove fasteners
from magazine before making adjustments or personal injury may
result..
If a nail becomes jammed in the
FIG. 10
nosepiece, keep the tool pointed
away from you and follow these
instructions to clear:
1. Disconnect the air supply
from the tool.
2. Push the door latch (D) to
open the nail guide door (G)
3. Open the canister cover (C).
4. Remove the jammed nail.
5. Correct any deformation that may have occurred to the nail coil.
NOTE: Should nails continue to jam frequently in nosepiece, have
tool serviced by an authorized D
e
WALT service center.
Cold Weather Operation
WARNING: Read the section titled Important Safety Instructions
at the beginning of this manual. Always wear eye and ear protection
when operating this tool. Keep the nailer pointed away from yourself
and others. For safe operation, complete the following procedures
and checks before each use of the nailer.
When operating tools at temperatures below freezing, complete
preparation procedures outlined above and follow the directions
below.
1. Make sure compressor tanks have been properly drained prior
to use. Always drain the compressor tanks at least once daily
while using the nailer. This is especially important in cold weather
because any moisture in the air in the tanks will condense in the
cold temperature.
English
11