Use and Care Manual

FIG. 4

Changing Bit Holders (Fig. 5)

1. Rotate the locking collar (C) 1/4 turn to unlock nose cone from

gearcase.

2. Pull nose cone (D) off of gear case.

3. To remove:

a. Grab the bit holder (M).

b. Push it into the gear case depressing the sleeve (L).

c. Rotate the bit holder until the clutch engages.

d. While holding the sleeve depressed, pull the bit holder out.

4. Push and rotate the new bit holder into gearcase, depressing the

sleeve, until ball lock snaps in groove in bit holder shank.

5. Replace nose cone (D) by placing on gear case and rotating collar

1/4 turn to align arrow on gear case with the lock symbol on

collar.

Changing Bit Tip (Fig. 5)

1. Rotate the locking collar (C) 1/4 turn to unlock nose cone from gear

case.

2. Pull nose cone (D) off of gear

case.

3. Use pliers to remove worn bit

and install new bit tip.

Depth Adjustment

Follow the graphic on the collar

to increase or decrease the

fastening depth. To seat the

screw deeper in the workpiece,

turn the adjustment collar to

the right. To seat the screw

higher in the workpiece, turn the

adjustment collar to the left.

Screwdriving (Fig. 1)

• For best results, hold the screwgun with the hand directly in line

with the fastener and press the variable speed switch with the last

one or two fingers of the hand. This reduces the chance of the

screw slipping from the drive accessory when pressure is applied.

• To drive the fastener, place it on the bit, press the variable speed

switch and push the fastener into the workpiece with a smooth,

continuous motion. When the fastener is seated, the clutch will

disengage automatically.

1. Install bit tip in bit holder.

2. Adjust depth locator (A).

3. Check for correct rotation, start screwgun and place screw on bit.

FIG. 5

English