Use and Care Manual

ENGLISH
9
holder, slide the flat head of the chuck key handle into the
chuck key holder
10
as shown. Snap the handle's shaft into
the retention clip
11
on theholder.
To remove the chuck key from its holder, pull the chuck key
handle out of the holder and slip the flat head out of thehole.
NOTE: To avoid losing the chuck key, do not store it in any
otherorientation.
Fig. F
10
6
11
6
Installing and Releasing a Bit (Fig. A)
Open the keyed chuck jaws by turning the collar by hand
then insert the shank of the bit about 3/4" (19 mm) into
chuck. Tighten the chuck collar by hand. Place chuck
key (
6
, Fig.A) in each of the three holes, and tighten
in clockwise direction. It’s important to tighten chuck
with all three holes. To release the bit, turn the chuck
counterclockwise in just one hole, then loosen the chuck
byhand.
NOTE: When using hex shank or three-sided shank bits, be
sure to align the flat sides of the bit with the chuck jaws to
ensure the bit is properly engaged by thejaws.
Worklight (Fig. A)

CAUTION: Do not stare into worklight. Serious eye
injury couldresult.
The worklight
7
is activated when the trigger is depressed,
and will remain on for a short time after the trigger is
released. If the trigger remains depressed, the worklight will
remainon.
NOTE: The worklight is for lighting the immediate work
surface and is not intended to be used as aflashlight.
DeWALT
Bluetooth® Tool Tag Ready
(Fig. A, G)
Optional Accessory

WARNING: Read instruction manual for the
DeWALT
Bluetooth® ToolTag.

WARNING: Remove battery from tool before installing
the
DeWALT
Bluetooth® ToolTag.

WARNING: When installing or replacing the
DeWALT
Bluetooth® Tool Tag, use only the screws provided. Be
sure to securely tighten thescrews.
Your tool comes with mounting holes and fasteners
12
for
installing a
DeWALT
Bluetooth® Tool Tag (DCE041). You will
need a flat-blade screwdriver to install the tag. Screw torque
should be between 0.8 and 1.2 Nm (7.1 to 10.6 in-lbs). The
DeWALT
Tool Tag is designed for tracking and locating
professional power tools, equipment, and machines using
the
DeWALT
Tool Connect™ app. For proper installation of
the
DeWALT
Tool Tag, refer to the
DeWALT
Tool Tagmanual.
To learn more,visit:
www.
DeWALT
.com/en-us/jobsite-solutions/tool-connect
Fig. G
12
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Installing and Removing the Battery Pack
(Fig. H)
NOTE: For best results, make sure your battery pack is
fullycharged.
To install the battery pack
1
into the tool handle, align the
battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does notdisengage.
To remove the battery pack from the tool, press the release
button
2
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of thismanual.