Instruction manual

7
DRILLING IN MASONRY
(D25113-XE, D25114-XE, D25213-XE, D25313-XE, D25314-XE)
When drilling in masonry, use SDS carbide tipped bits rated for percussion drilling and
be certain that the bit is sharp. Use a constant and firm force on the tool to drill most
effectively. A smooth, even flow of dust indicates the proper drilling rate.
DEPTH ROD
To adjust the depth rod.
1. Push in and hold the button on the side handle.
2. Move the depth rod (B) so the distance between the end of the rod and the end
of the bit equals the desired drilling depth.
3. Release the button to lock rod into position. When drilling with the depth rod,
stop when end of rod reaches surface of material.
MAINTENANCE
WARNING: Shock Hazard. To reduce the risk of serious personal injury, turn tool
off and disconnect tool from power source before making any adjustments or
removing/installing attachments or accessories.
Cleaning
CAUTION: Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals may weaken the plastic materials used in
these parts. Use a cloth dampened only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool into a liquid.
Lubrication
Your tool was properly lubricated before leaving the factory. In from two to six
months, depending upon use, take or send your tool to an authorized service
center for a complete cleaning, inspection and lubrication. Tools used constantly
on production jobs will need relubrication more often. Also, tools “out of service” for
long periods should be relubricated before being put back to work.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING: Since accessories, other than those offered by DEWALT, have not been
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only DEWALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at extra cost from your
local service center. If you need any assistance in locating any accessory, please con-
tact DEWALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138 Australia or
call 1800 654 155 or (NZ) 09 579 7600.
MAXIMUM RECOMMENDED CAPACITIES
D25113-XE, D25114-XE
D25213-XE, D25314-XE, D25315-XE
Masonry 26 mm (1")
Steel 12.7 mm (1/2")
Wood 38 mm (1-1/2")
OPTIMUM CAPACITY
Masonry 4 mm - 16 mm
(5/32"-5/8")
Guarantee
Applicable to hand held Power Tools, Lasers and Nailers.
Three Year Limited Warranty
DEWALT will repair, without charge, any defects due to faulty materials or
workmanship for three years from the date of purchase. Please return the complete
unit, transportation prepaid, to any DEWALT Service Centre, or any authorised
service station.
For warranty repair information, call (AUS) 1800 654 155 or (NZ) 09 579 7600.
This warranty does not apply to
• Accessories
• Damage caused where repairs have been made or attempted by others.
• Damage due to misuse, neglect, wear and tear, alteration or modification.