pdf-doc

aDhesiVe anchors
www.powers.com
24
TECH MANUAL – ADHESIVE ANCHORS ©2015 POWERS VOLUME 1 – 9/2015 – REV. G
REFERENCE TABLES FOR INSTALLATION
REFERENCE TABLES FOR INSTALLATION
Gel (working) Time and Curing Table
Temperature of Base Material
Gel (working) Time Full Curing Time
˚F ˚C
41 5 180 minutes 50 hours
50 10 120 minutes 30 hours
68 20 30 minutes 10 hours
86 30 20 minutes 6 hours
104 40 20 minutes 4 hours
Hole Cleaning Equipment Selection Table for PE1000+
Threaded rod
diameter
(inch)
Rebar size
(no.)
ANSI drill bit
diameter
(inch)
Min. brush
diameter, D
min
(inches)
Brush length, L
(inches)
Steel wire
brush
(Cat. #)
Blowout
tool
Number of
cleaning actions
3/8 #3 7/16 0.475 6-3/4 08284
Hand-pump
or
compressed air
nozzle
(min. 90 psi)
4x blowing
4x brushing
4x blowing
1/2 #4 9/16 0.600 6-3/4 08285
5/8 #5
11/16 0.735 7-7/8 08286
3/4 0.790 7-7/8 08278
3/4 #6 7/8 0.920 7-7/8 08287
7/8 #7 1 1.045 11-7/8 08288
Compressed air
nozzle only
(min. 90 psi)
1 #8 1-1/8 1.175 11-7/8 08289
1-1/4 #9 1-3/8 1.425 11-7/8 08290
- #10 1-1/2 1.550 11-7/8 08291
1. An SDS-plus adaptor (Cat. #08283) or Jacobs chuck style adaptor (Cat. #08296) is required to attach a steel wire brush to the drill tool.
2. For installations with 5/8 threaded rod and #5 rebar size, the preferred ANSI drill bit diameter is 3/4-inch. If an 11/16-inch ANSI drill bit is used the user must check before injecting the
adhesive to verify that the steel anchor element can be inserted into the cleaned bore hole without resistance.
Adhesive Piston Plugs
Threaded Rod
Diameter
(inch)
Rebar
Size
(no.)
ANSI Drill Bit
Diameter
(inch)
Plug
Size
(inch)
Plastic
Plug
(Cat. #)
Horizontal and overhead
installations
3/4 #6 7/8 7/8 08300
7/8 #7 1 1 08301
1 #8 1-1/8 1-1/8 08303
1-1/4 - 1-3/8 1-3/8 08305
- #10 1-1/2 1-1/2 08309
A plastic extension tube (3/8" dia., Cat. #08291 or Cat. #08297) must be used with piston plugs.