DeWALT Owners Manual

ENGLISH
9
6. Move the locking arm back into place, push the tab back
down so the pin engages the lockingarm.
Fig. E
14
15
Fig. F
12
13
15
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Belt Hook (Optional Accessory) (Fig. A)

WARNING: Drop Hazard. To reduce the risk of
serious personal injury, DO NOT use the belt hook
for tethering or securing the tool to a person or object
during use whenelevated.

WARNING: To reduce the risk of serious personal
injury, DO NOT suspend tool overhead or
suspend objects from the belt hook. ONLY hang
tool’s belt hook from a workbelt.

WARNING: To reduce the risk of serious personal
injury, ensure the screw holding the belt hook
issecure.
NOTE: Bit clip and belt hook cannot be used with the
lanyard-ready attachment kitinstalled.
IMPORTANT: When attaching or replacing the belt hook,
use only the screw
9
that is provided. Be sure to securely
tighten thescrew.
The belt hook
8
can be be attached to either side of the
tool using only the screw
9
provided, to accommodate left-
or right- handed users. If the hook is not desired at all, it can
be removed from thetool.
To move belt hook, remove the screw
9
that holds the belt
hook in place then reassemble on the opposite side. Be sure
to securely tighten thescrew.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Installing and Removing the Battery Pack
(Fig. G)
Fig. G
5 6
NOTE: For best results, make sure your battery pack is
fullycharged.
To install the battery pack
6
into the tool handle, align the
battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does notdisengage.
To remove the battery pack from the tool, press the release
button
5
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of thismanual.
Proper Hand Position (Fig. H)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
suddenreaction.
Proper hand position requires one hand on the main
handle
10
.