Product Manual
English
CAUTION: Ensure the lock-off switch is in the locked
position to prevent the trigger switch from moving and the battery is
removed before attaching or removing the tube (E). The tube must be
attached to the housing (3A) before use.
TUBE ASSEMBLY: To attach the
FIG. 3
E
3A
3B
3C
3D
tube to the blower, line up the pegs
housing opening as shown in
blower housing until the lock
engages the tube.
securely in place.
WARNING: Do not operate blower without tube
securely in place. Never reach down into housing through tube hole.
WARNING: Always slide the lock-off switch to the
locked position and remove the battery when:
• You leave blower unattended.
• Checking, adjusting, cleaning, or working on blower.
WARNING: Before removing or installing battery,
make certain the lock-off switch (C) is in the locked position to prevent
switch actuation.
WARNING: Shock hazard. Don’t allow any liquid to
get inside the charger. Electric shock may result.
WARNING: Burn hazard. Do not submerge the battery
pack in any liquid or allow any liquid to enter the battery pack. Never
attempt to open the battery pack for any reason. If the plastic housing of
the battery pack breaks or cracks, return to a service center for recycling.
1. The best storage place is one that is cool and dry, away from direct
sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully charged battery
pack in a cool dry place out of the charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of
charge. The battery pack will need to be recharged before use.
A. Trigger switch E. Tube
B. Speed lock lever F. Battery housing
D. Handle H. Battery release button
G
F
E
A
FIG. 2
D
B
C
H